Sandpiper SA25 Manual do Utilizador

sa1dl4sm-rev0611Copyright 2011 Warren Rupp, Inc. All rights reserved.Table of ContentsEngineering Data, Temperature Limitations, & Performance Cur

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 9This pump is pressurized internally with air pressure during operation. Always make certain that

Model SA1, SA25 Type 4 Page 10 sa1dl4sm-rev0611 Grounding The PumpTo reduce the risk of static electrical sparking, this pump must be grounded. Che

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 11    

Model SA1, SA25 Type 4 Page 12 sa1dl4sm-rev0611 ITEM TOTAL NO. PART NUMBER DESCRIPTION RQD. 1 165-042-157 Cap, Valve Body (AL Center)

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 13 ITEM TOTAL NO. PART NUMBER DESCRIPTION RQD. 38 545-004-330 Nut, Hex 2039 115-071-080

Model SA1, SA25 Type 4 Page 14 sa1dl4sm-rev0611 SuctionDischarge61 (SS & Alloy C units only)(62)

Signature of authorized personRevision Level: EPrinted name of authorized personDavid RoseberryDate of issueOctober 20, 2005TitleEngineering ManagerDa

In accordance with ATEX Directive 94/9/EC, Equipment intended for use in potentially explosive environments.EN 60079-25: 2004For pumps equipped with P

EC Declaration of ConformityATEX Summary of MarkingsType Marking Listed InNon-Conductive FluidsEC Type Certificate No. Pumps: KEMA 09ATEX0071 X T

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 1SA1 Type 4 SA25 Type 4 FLAP-VALVEPERFORMANCE CURVES® pumps are designed to be powered only by compr

Model SA1, SA25 Type 4 Page 2 sa1dl4sm-rev0611 SA1 & SA25Copyright© 2009 IDEX AODD, Inc. All rights reserved. Speci

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 3SA1 & SA25Copyright© 2009 IDEX AODD, Inc. All rights reserved. Specif

Model SA1, SA25 Type 4 Page 4 sa1dl4sm-rev0611 PLEASE NOTE!The photos shown in this manual are for general instruction only. Your specic model may

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 5AIR SUPPLYAir supply pressures cannot exceed 125 psi (8.61 bar). Connect the pump air inlet to an a

Model SA1, SA25 Type 4 Page 6 sa1dl4sm-rev0611 capscrew of the opposite side to keep the rod from rotating. If the opposite chamber is assembled, t

sa1dl4sm-rev0611 Model SA1, SA25 Type 4 Page 7Remove the spool from the sleeve. Using an arbor press or bench vise (with an improvise

Model SA1, SA25 Type 4 Page 8 sa1dl4sm-rev0611 B. Make certain the suction line or strainer is not plugged. Restriction at the suction is indicate